M-audio xponent

The script was written with the Mixco mapping framework. Holding the corresponding deck's shift button while pressing the Big Minus button will do a rolling reverse censor mode , and will resume play at the point the track would have been if the Big Minus had never been pressed. Temporarily speeds up or slows down the corresponding track.

Uploader: Douktilar
Date Added: 12 February 2018
File Size: 38.58 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 23870
Price: Free* [*Free Regsitration Required]





This preference can be set in the config section of the M-Audio-Xponent-Advanced-scripts.

All the way to the left sends only the track s selected by the PFL buttons see 12 to the headphones. The four knobs and buttons below each jogwheel perform different functions.

The Midi mode see 19 is not mapped at this time. The 1, 2, 4, and 8 buttons behave as normal, starting a loop of X beats at the current position.

The upper numbered buttons set or activate hotcues. Controls the volume of the headphones. Controls the volume of the master audio output. The Gain kill Gwill momentarily silence the track entirely.

This behavior can be switched to behave as a master-out meter instead by xlonent the value of MaudioXponent. The right-hand side controls effects. Connector 2 is the main out, and Connector 1 is the headphones. Holding shift while pressing it toggles Quantize on and off for that deck. Controls the volume of the booth audio output. These MIDI inputs are not used in this mapping.

These will be mentioned in-line.

Mapping(s) for M-Audio, Torq Xponent

User Tools Register Log In. Except where otherwise noted, content on this wiki is licensed under the following license: Displays the current output level for the corresponding deck. Once an effect has the focus, pressing the button again will toggle it on and off. When scratch mode is enabled, moving the wheel by touching the top surface will scratch, while moving the wheel by touching the outer ring will act as a normal jog-wheel.

The knobs will control the parameters of the effect that currently has the focus. This documentation should be considered preliminary and subject to change.

m-audio_xponent [Mixxx Wiki]

Normal play will resume when it is released. Wait until the Xponent is completely started up red progress LEDS on both decks are fully lit then release the keys. Selects which track s are heard through the headphone output This mapping has two PFL modes. M-aydio script was written with the Mixco mapping framework. Momentarily pulls the cross-fader to the center position while pressed. Alters the behavior of certain controls.

This mapping expands on the stock 2. Indicates the progress through the corresponding track. Holding the corresponding deck's shift button while pressing the Big Minus button will do a rolling reverse censor modeand will resume play m-audioo the point the track would have been if the Big Minus had never been pressed.

Pressing the already-selected PFL button will disable it.

Holding both shift keys while pressing either gain kill button will toggle the vu meters between master output mode and per-channel mode see xponeent When the track is stopped, the jog wheel seeks forward and backward in the corresponding track.

Pressing the same button again while looping will exit that loop. Acts as a mouse input to the computer.

1 Comment on "M-audio xponent"

  1. Duzragore | 11.10.2018 at 10:05 | Reply

    I apologise, but, in my opinion, you are not right. Let's discuss it. Write to me in PM.

  2. In it something is. Now all is clear, I thank for the information.